Bedford CF-UK Message Board Logo [Home] [Search] [FAQ]
Bedford CF-UK Message Board > CF Questions > Ignition timing marks, CF2 2.0T
[Private Message] [Register] [Profile] [Member list] [Log-in]
Who's Online:
There are 0 member(s), and 1 guest(s) online.
 
[Printable Version] [Post Reply]
Author Message
Anon
Deleted
Posts :
Location :
Status    : Offline

Ignition timing marks, CF2 2.0T

Hi,

Could anyone explain (or even better, show with a picture) where the timing marks are on a 1986 CF2 (2.0T petrol engine)

The Haynes manual is very vague

Thanks

Stu

----------------------
Tue 19 May 2015 @ 21:47 Edit this messageQuote this messagePMQuote this message
bluebedouin
Global Moderator
Posts : 2444
Location : Northampton,England.
Status    : Offline

Go to the File Downloads Section & click the link to Dropbox in my CF Manuals thread.Group 13 covers the electrical system.

----------------------
Tue 19 May 2015 @ 22:25 View bluebedouin   Email bluebedouin   Edit this messageQuote this messagePMQuote this message
Anon
Deleted
Posts :
Location :
Status    : Offline

Unfortunately it doesn't seem to cover the CF2 engine
Tue 19 May 2015 @ 22:55 Edit this messageQuote this messagePMQuote this message
Gethin
Card Holder
Posts : 462
Location : east lancs
Status    : Offline

If you look at the drivers side of the engine , at the back you will find a cut out with a pointer and a raised rivet on a small plate attached to the rear casing.

When no 1 piston is on compression stroke, when on TDC you should see a dimple in the flywheel.

5'BTDC is when this dimple is aligned with the pointer. TDC is when aligned with the rivet .
Thu 21 May 2015 @ 21:21 View Gethin   Email Gethin   Edit this messageQuote this messagePMQuote this message
Anon
Deleted
Posts :
Location :
Status    : Offline

Gethin wrote:
If you look at the drivers side of the engine , at the back you will find a cut out with a pointer and a raised rivet on a small plate attached to the rear casing.

When no 1 piston is on compression stroke, when on TDC you should see a dimple in the flywheel.

5'BTDC is when this dimple is aligned with the pointer. TDC is when aligned with the rivet .


Great, thanks. Will take a look and see if I can find them.


Thu 21 May 2015 @ 21:28 Edit this messageQuote this messagePMQuote this message
Gethin
Card Holder
Posts : 462
Location : east lancs
Status    : Offline


(c) Vauxhall Heritage Archive'
Thu 21 May 2015 @ 22:11 View Gethin   Email Gethin   Edit this messageQuote this messagePMQuote this message
Anon
Deleted
Posts :
Location :
Status    : Offline

Gethin wrote:


Thanks, that will be a great help
Fri 22 May 2015 @ 17:26 Edit this messageQuote this messagePMQuote this message
Time in GMT
[Post Reply]
New posts since your last visit Administrative Functions: Open/Close/Delete Thread / Move Thread
Old post

Forum Jump:

Back to the CF-UK Homepage ][ Email CF-UK

Powered by FunkBoard vCF0.74c